Texas Instruments SN74HC595DR

SN74HC595DR Overview
Embedded in a package of type 16-SOIC (0.154, 3.90mm Width), the device is available for use. Chip terminations add up to 16. The Cut Tape (CT) case contains it. Its operating supply voltage is rated at 5V. The device is equipped with 16 pins. Surface Mount is recommended for mounting. An electronic component is included in the HC/UH. There is a component mounted in the way of Surface Mount on this board. There is a range of temperatures -40°C~85°C for operation. There is a voltage supply within 2V~6V. In the 74HC series, this electrical component is found. Search for similar parts based on the 74HC595 family. It is noted that the operating supply voltage of this chip falls within the range 5V. Taking note of the following additional details: PARALLEL OUTPUT IS REGISTERED; UNREGISTERED SERIAL SHIFT RIGHT OUTPUT. For this part, the minimum supply voltage (Vsup) should not be less than 2V. A voltage of 2/6V can be delivered by it. This part requires a maximum supply voltage (Vsup) of 6V. A total of 10 output lines are available for operation. There is a quiescent current of 8μA in this circuit. TR is the packaging way for the part. The device runs at 42MHz. The part is equipped with 9 outputs.

SN74HC595DR Features
With 16 pins
Mounted in Surface Mount type.
Based on 74HC595 family
Operate supply voltage at 5V
It supplies 2/6V power
With 10 output lines
Quiescent Current at 8μA
Packing Method : TR

SN74HC595DR Applications
There are a lot of Texas Instruments SN74HC595DR Shift Registers applications.

Remote control holding register
Data Processors
Dual-rank shift, hold, and bus applications
Data Format Converters
Serial-to-parallel data conversion
data transfer
data manipulation
temporary data storage
Output expansion
7-segment display control