Texas Instruments PGA116AIPWR

PGA116AIPWR Overview
Packaged in a 20-TSSOP (0.173, 4.40mm Width) case, the buffer op amp is ready to use. An op amp ic of the Programmable Gain type. The op amp is delivered to you in a Tape & Reel (TR) case. There is a growing number of terminations approaching the number of 20. The pins on this board total to 20 in total. I would like to remind you that this buffer op amp should be powered by an 5V battery. I would like to specify that this buffer amplifier belongs to the Other Analog ICs-type of devices. A total of 20 pins are present on the instrumentation amplifier. There is an input offset voltage of 325μV for this buffer op amp. The mounting type that is recommended for this electrical part is Surface Mount. In relation to the operating temperature of this buffer op amp, it works well at an average of -40°C~125°C . As long as the supply current of the chip does not exceed 330μA, this op amp ic can operate. During the manufacturing process, this buffer amplifier is divided into 1 circuits. As far as the device is concerned, buffer amplifier has 10 channels. One of the many advantages that this linear amplifier has, among many other things, is the fact that it outputs Rail-to-Rail signals. Currently, linear amplifier is operating with a quiescent current of 1.1mA. Linear amplifier resistance should stay within the range of 10GOhm. It should be noted that the other type of analog integrated circuit used in this instrumentation amplifier is known as the ANALOG CIRCUIT.

PGA116AIPWR Features
20 Pins
supply voltage of 5V
Output Type: Rail-to-Rail
Resistance of 10GOhm


PGA116AIPWR Applications
There are a lot of Texas Instruments
PGA116AIPWR Instrumentational OP Amps applications.


Integrator circuits
Differentiator circuits
Logarithmic operation circuits
Exponential operation circuits
Multiplication circuits
Division circuits
Precision measurement
Power control
Information processing
Weak signal detection