Texas Instruments OPA4137UA/2K5

OPA4137UA/2K5 Overview
In order to protect the op amps, a 14-SOIC (0.154, 3.90mm Width) case is used. There are two types of operational amplifiers in this circuit. In the case of Tape & Reel (TR) cases, linear amplifier will be delivered. In recent months, the number of terminations has approached 14. It consists of a total of 14 pins in total. It would be helpful if you could remember that this op amp ic should be powered by an 15V battery. A type of Operational Amplifier buffer op amp is what this device is specifically, to be more precise. It has 14 pins that make up the linear amplifier. In terms of input offset voltage, operational amplifier rates 10mV. This electronic component is recommended to be mounted using the mounting type Surface Mount. It is recommended that this op amp ic be operated at a temperature no higher than -40°C~85°C for optimal performance. 94dB should remain the voltage gain. In total, there are 4 circuits on this buffer amplifier. For the operating supply voltage of the op amp ic, there is a rating of 4. The operating supply voltage of the buffer op amp is rated at 18V. As a result of this, the buffer amplifier is packed in TR. MicroAmplifier™ is the number that corresponds to the series of the buffer op amp.

OPA4137UA/2K5 Features
14 Pins
supply voltage of 15V
94dB voltage gain


OPA4137UA/2K5 Applications
There are a lot of Texas Instruments
OPA4137UA/2K5 Instrumentational OP Amps applications.


Differentiator circuits
Logarithmic operation circuits
Exponential operation circuits
Multiplication circuits
Division circuits
Precision measurement
Power control
Information processing
Weak signal detection
Signal amplification