Texas Instruments OPA2349UA/2K5G4

OPA2349UA/2K5G4 Overview
In the package, you will find a SOIC-case to contain the op amp ic. The instrumentation amplifier in this picture is of the OPERATIONAL AMPLIFIER-type. A Tape and Reel case is used for delivering the op amp. During the past two weeks, there have been close to 8 terminations. A total of 8 pins are located on this board. This linear amplifier should be powered by an 5V battery. This particular linear amplifier is a type of Operational Amplifier device, to be precise. The op amp ic has an array of 8 pins on it. Op amp rates 10mV as input offset voltage. Using an 1μA supply current, this operational amplifier ics can be operated. You should keep the voltage gain at 90dB for the time being. To operate this buffer amplifier, the temperature must not be lower than -55°C. A temperature greater than 125°C should not be used for the operation of buffer amplifier. 2 elements make up the design of this buffer amplifier. This electric component can work from a voltage of under 5.5V as far as supply voltage is concerned. A voltage of 1.8V or higher is recommended for the linear amplifier's supply voltage.

OPA2349UA/2K5G4 Features
8 Pins
supply voltage of 5V
90dB voltage gain


OPA2349UA/2K5G4 Applications
There are a lot of Texas Instruments
OPA2349UA/2K5G4 Instrumentational OP Amps applications.


Multiplication circuits
Division circuits
Precision measurement
Power control
Information processing
Weak signal detection
Signal amplification
Signal filtering
Signal operation
Video computer boards