Texas Instruments OPA228UAG4

OPA228UAG4 Overview
The linear amplifier is packaged in a 8-SOIC (0.154, 3.90mm Width) case. There are two types of operational amplifiers in this circuit. A Tube case is used to deliver the buffer op amp. There is a growing number of terminations approaching the number of 8. The pins on this board total to 8 in total. It would be helpful if you could remember that this op amp ic should be powered by an 15V battery. To be specific, this instrumentation amplifier is a type of Operational Amplifier. The op amp ic has an array of 8 pins on it. Op amp rates 200μV as input offset voltage. Surface Mount is the recommended mounting type for this linear amplifier. It is recommended that this op amp ic be operated at a temperature no higher than -40°C~85°C for optimal performance. It is possible to operate this buffer amplifier from a supply current of 3.7mA . The voltage gain should stay at 160dB. Op amp has total of 1 elements. The operating supply voltage of instrumentation amplifier is rated 18V voltage.

OPA228UAG4 Features
8 Pins
supply voltage of 15V
160dB voltage gain

OPA228UAG4 Applications
There are a lot of Texas Instruments OPA228UAG4 Instrumentational OP Amps applications.

Signal amplification
Blood pressure sensors
Car stereo
Digital cameras
Measurements of Wheatstone bridge
Power control
Radar
Signal transformation
Polarized electrodes
Radiation thermometry transducers