Texas Instruments OPA1642AIDGKT

OPA1642AIDGKT Overview
Packaged in a 8-TSSOP, 8-MSOP (0.118, 3.00mm Width) case, the buffer op amp is ready to use. Audio-type instrumentation amplifiers are used in this application. Instrumentation amplifier is delivered in a Tape & Reel (TR) case. There have been a total of 8 terminations over the past year. In this case, there are 8 pins on the board. Please take in mind that op amp should be run at 18V. A type of Operational Amplifier op amp ic can be identified by the fact that this is a type of Operational Amplifier device. It has 8 pins that make up the linear amplifier. The input offset voltage is 3.5mV. This electronic part is best mounted with type Surface Mount. Regarding the operating temperature of this device, instrumentation amplifier performs well at a temperature of -40°C~85°C . As long as the supply current of the chip does not exceed 1.8mA, this op amp ic can operate. There should be no change in the voltage gain at 134dB. As far as the device is concerned, buffer amplifier has 2 channels. There are more than a few advantages to using this instrumentation amplifier, one of which is that it outputs Rail-to-Rail signals. It is used TR to pack the op amps. In this case, SoundPlus? represents the instrumentation amplifiers' series number.

OPA1642AIDGKT Features
8 Pins
supply voltage of 18V
134dB voltage gain
Output Type: Rail-to-Rail

OPA1642AIDGKT Applications
There are a lot of Texas Instruments OPA1642AIDGKT Instrumentational OP Amps applications.

Proportional counter tubes
Multimedia playback equipment
earphone
Logarithmic operation circuits
Portable docking station
High speed sample
Signal transformation
Scintillation detectors
Portable media players
ECG equipment