Texas Instruments MC1458P1

MC1458P1 Overview
A PDIP case is used to package the op amp. OPERATIONAL AMPLIFIER-type instrumentation amplifiers are used in this application. It is estimated that there will be 8 terminations in the next few months. There are a total of 8 pins on this op amp. It is important to remember that this op amp should be operated at a voltage of 15V volts. It should be noted that this op amp is a type of Operational Amplifier device. There are 8 pins on this chip. In terms of the input offset voltage, instrumentation amplifier rates at 1mV. An 3.4mA volt supply current is needed for this linear amplifier to operate. There are 2 channels on the operational amplifiers. In order for op amp to function properly, the temperature should not be lower than 0°C degrees Celsius. Instrumentation amplifier should only be used at temperatures up to 70°C. I would like to point out that this electrical component is capable of working from a voltage below 36V as far as the power supply is concerned. As a general rule, it is advisable to keep the op amp's supply voltage above 6V at all times. There is a minimum voltage gain of 15000 that this buffer op amp is capable of conducting.

MC1458P1 Features
8 Pins
supply voltage of 15V


MC1458P1 Applications
There are a lot of Texas Instruments
MC1458P1 Instrumentational OP Amps applications.


Addition operation circuits
Subtraction operation circuits
single/dual op amp sum and difference circuits
Integrator circuits
Differentiator circuits
Logarithmic operation circuits
Exponential operation circuits
Multiplication circuits
Division circuits
Precision measurement