Maxim Integrated MAX435CPD

MAX435CPD Overview
Packaged in a 14-DIP (0.300, 7.62mm) case, the buffer op amp is ready to use. An op amp ic of the Transconductance type. The op amp is delivered to you in a Tube case. There is a growing number of terminations approaching the number of 14. The pins on this board total to 14 in total. I would like to remind you that this buffer op amp should be powered by an 5V battery. I would like to specify that this buffer amplifier belongs to the Operational Amplifier-type of devices. The mounting type that is recommended for this electrical part is Through Hole. In relation to the operating temperature of this buffer op amp, it works well at an average of 0°C~70°C . During the manufacturing process, this buffer amplifier is divided into 1 circuits. One of the many advantages that this linear amplifier has, among many other things, is the fact that it outputs Differential signals. As a result, it is recommended that a power supply of 35mA be used with this electronic part.

MAX435CPD Features
14 Pins
supply voltage of 5V
Output Type: Differential


MAX435CPD Applications
There are a lot of Rochester Electronics, LLC
MAX435CPD Instrumentational OP Amps applications.


Integrator circuits
Differentiator circuits
Logarithmic operation circuits
Exponential operation circuits
Multiplication circuits
Division circuits
Precision measurement
Power control
Information processing
Weak signal detection