Linear Technology LT1210CR#TRPBF

LT1210CR#TRPBF Overview
A TO-263-8, D2Pak (7 Leads Tab), TO-263CA case is used to package the op amp. Current Feedback-type instrumentation amplifiers are used in this application. The case in which buffer amplifier is delivered is called a Tape & Reel (TR) case. It is estimated that there will be 7 terminations in the next few months. There are a total of 7 pins on this op amp. It is important to remember that this op amp should be operated at a voltage of 5V volts. It should be noted that this op amp is a type of Operational Amplifier device. There are 7 pins on this chip. In terms of the input offset voltage, instrumentation amplifier rates at 3mV. It is recommended that this electronic component be mounted using the Surface Mount mounting type. In terms of operating temperature, this instrumentation amplifier performs well at a temperature of about 0°C~70°C . An 35mA volt supply current is needed for this linear amplifier to operate. There should be no change in the voltage gain. There are a total of 1 elements in this linear amplifier. The instrumentation amplifier is packed in the form of TAPE AND REEL.

LT1210CR#TRPBF Features
7 Pins
supply voltage of 5V
71dB voltage gain


LT1210CR#TRPBF Applications
There are a lot of Linear Technology/Analog Devices
LT1210CR#TRPBF Instrumentational OP Amps applications.


Addition operation circuits
Subtraction operation circuits
single/dual op amp sum and difference circuits
Integrator circuits
Differentiator circuits
Logarithmic operation circuits
Exponential operation circuits
Multiplication circuits
Division circuits
Precision measurement