Texas Instruments LOG100JP

LOG100JP Overview
In order to protect the op amps, a 14-CDIP (0.300, 7.62mm) case is used. There are two types of operational amplifiers in this circuit. In the case of Tube cases, linear amplifier will be delivered. In recent months, the number of terminations has approached 14. It consists of a total of 14 pins in total. It would be helpful if you could remember that this op amp ic should be powered by an 15V battery. This electronic component is recommended to be mounted using the mounting type Through Hole. It is recommended that this op amp ic be operated at a temperature no higher than 0°C~70°C for optimal performance. In total, there are 1 circuits on this buffer amplifier. This electronic part is recommended to be used with an 7mA supply for best performance. Besides the analog ICs used in this instrumentation amplifier, there is also another type of analog IC called LOG OR ANTILOG AMPLIFIER IC.

LOG100JP Features
14 Pins
supply voltage of 15V


LOG100JP Applications
There are a lot of Rochester Electronics, LLC
LOG100JP Instrumentational OP Amps applications.


Differentiator circuits
Logarithmic operation circuits
Exponential operation circuits
Multiplication circuits
Division circuits
Precision measurement
Power control
Information processing
Weak signal detection
Signal amplification