Texas Instruments LMV344MTX

LMV344MTX Overview
Packaging for the buffer amplifier is in the form of a 14-TSSOP (0.173, 4.40mm Width) case. A General Purpose-type buffer amplifier is shown here. There is a Tape & Reel (TR) case that is delivered with the instrumentation amplifiers. A total of 14 terminations have been reported in the past few weeks. Buffer amplifier has a total of 14 pins on it. I would like you to keep in mind that this buffer amplifier needs to be run at a voltage of 2.7V. In more specific terms, this linear amplifier can be categoriOperational Amplifiered as a Operational Amplifier-type device. For this electrical component, the recommended mounting type is Surface Mount, which is the most common. The buffer amplifier functions well at -40°C~125°C as far as operating temperature is concerned. The buffer amp consists of 4 circuits in total. There are more than a few advantages to using this instrumentation amplifier, one of which is that it outputs Rail-to-Rail signals. A TAPE AND REEL-shaped amplifier is used to pack the buffer amps. A supply of 107μA or higher is recommended for use with this electronic part. There are a maximum of 1580 voltage gains that can be conducted by this operational amplifier at its minimum voltage gain.

LMV344MTX Features
14 Pins
supply voltage of 2.7V
Output Type: Rail-to-Rail


LMV344MTX Applications
There are a lot of Texas Instruments
LMV344MTX Instrumentational OP Amps applications.


single/dual op amp sum and difference circuits
Integrator circuits
Differentiator circuits
Logarithmic operation circuits
Exponential operation circuits
Multiplication circuits
Division circuits
Precision measurement
Power control
Information processing