Texas Instruments LMV324MTX/NOPB

LMV324MTX/NOPB Overview
In order to protect the op amps, a 14-TSSOP (0.173, 4.40mm Width) case is used. A General Purpose-type buffer amplifier is shown here. Linear amplifier is delivered in a Tape & Reel (TR) case. It is estimated that there will be 14 terminations in the next few months. It consists of a total of 14 pins in total. It would be helpful if you could remember that this op amp ic should be powered by an 5V battery. Instrumentation amplifier is a part of Operational Amplifier. 14 pins are located on the operational amplifiers. Op amp rates 7mV as input offset voltage. Surface Mount is the recommended mounting type for this linear amplifier. With regard to operating temperature, this op amp functions well at -40°C~85°C. As long as the supply current of the chip does not exceed 410μA, this op amp ic can operate. 100dB should remain the voltage gain. As far as the device is concerned, buffer amplifier has 4 channels. There are more than a few advantages to using this instrumentation amplifier, one of which is that it outputs Rail-to-Rail signals. An buffer amplifier is packed in a TR-shape according to the design.

LMV324MTX/NOPB Features
14 Pins
supply voltage of 5V
100dB voltage gain
Output Type: Rail-to-Rail

LMV324MTX/NOPB Applications
There are a lot of Texas Instruments LMV324MTX/NOPB Instrumentational OP Amps applications.

Active probe
Measurements of Wheatstone bridge
Gaming industry
Weak signal detection
Television broadcasting equipment
Thermocouples
Laptop
ECG equipment
Biopotential
Signal amplification