Texas Instruments LM358DRG3

LM358DRG3 Overview
Packaged in a 8-SOIC (0.154, 3.90mm Width) case, the buffer op amp is ready to use. An op amp ic of the General Purpose type. As far as the packaging is concerned, buffer op amp is delivered in a Tape & Reel (TR) case. It is estimated that there will be 8 terminations in the next few months. Buffer amplifier has a total of 8 pins. It would be helpful if you could remember that this op amp ic should be powered by an 5V battery. A type of Operational Amplifier buffer op amp is what this device is specifically, to be more precise. 8 pins are located on the operational amplifiers. With regards to the offset voltage of the input, buffer amplifier is rated at 3mV. For this electronic part, it is recommended that you mount it with type Surface Mount. It is recommended that this op amp ic be operated at a temperature no higher than 0°C~70°C for optimal performance. A supply current of 1mA can be used to operate this linear amplifier. Keeping the voltage gain at 100dB is the best course of action. Op amp ic has 2 channels. The operating supply voltage of the buffer op amp is rated at 16V. For packing the buffer amplifier, the TR-axis is adopted.

LM358DRG3 Features
8 Pins
supply voltage of 5V
100dB voltage gain

LM358DRG3 Applications
There are a lot of Texas Instruments LM358DRG3 Instrumentational OP Amps applications.

Comparator
Exponential operation circuits
Blood pressure sensors
Vehicle electronics
Portable media players
Strain gauges
E-book readers
Power transmission
Weak signal detection
Semiconductor detectors