Texas Instruments LM124DR

LM124DR Overview
It is packaged in an 14-SOIC (0.154, 3.90mm Width)-case that protects the operational amplifiers from damage. An op amp of this type is a General Purpose-type. As far as the packaging is concerned, buffer op amp is delivered in a Tape & Reel (TR) case. In total, the buffer amplifier consists of 14 pins. Op amp ic rates 5mV for input offset voltage. This electronic part is recommended for mounting type Surface Mount. In terms of operating temperature, this instrumentation amplifier is well suited to a temperature range of -55°C~125°C. A supply current of 1.4mA can be used to operate this linear amplifier. There should be no change in the voltage gain at 100dB. This op amp ic has 4 circuits. There are a total of 4 channels available on the op amps. This instrumentation amplifier cannot operate below -55°C degrees Celsius. You should only use op amp buffer at temperatures that are no higher than 125°C. There are 4 elements in this buffer amplifier. The operating supply voltage of the buffer op amp is rated at 16V. For optimal performance, this electrical part should be connected to a supply with a current of 1.4mA. It is important to keep in mind that the power supply voltage of this electric component is below 32V, which is suitable. Keeping the linear amplifier's supply voltage above 3V is recommended. In order to conduct this part, you will need to provide dual supply voltages of 16V volts.

LM124DR Features
100dB voltage gain


LM124DR Applications
There are a lot of Texas Instruments
LM124DR Instrumentational OP Amps applications.


Logarithmic operation circuits
Exponential operation circuits
Multiplication circuits
Division circuits
Precision measurement
Power control
Information processing
Weak signal detection
Signal amplification
Signal filtering