Texas Instruments INA129PAG4

INA129PAG4 Overview
It is packaged in an PDIP-case that protects the operational amplifiers from damage. An op amp of this type is a INSTRUMENTATION AMPLIFIER-type. It is estimated that there will be at least 8 terminations this year. A total of 8 pins are attached to buffer op amp. As a reminder, this buffer op amp should be powered by 15V battery and that the battery should be inserted in the amplifier. A type of Instrumentation Amplifier op amp ic can be identified by the fact that this is a type of Instrumentation Amplifier device. In total, the buffer amplifier consists of 8 pins. Op amp ic rates 25μV for input offset voltage. A supply current of 700μA can be used to operate this linear amplifier. There should be no change in the voltage gain at 80dB. There are a total of 1 channels available on the op amps. This instrumentation amplifier cannot operate below -40°C degrees Celsius. You should only use op amp buffer at temperatures that are no higher than 125°C. There are 3 elements in this buffer amplifier. It is important to keep in mind that the power supply voltage of this electric component is below 36V, which is suitable. Keeping the linear amplifier's supply voltage above 4.5V is recommended. In order to conduct this part, you will need to provide dual supply voltages of 18V volts. The quiescent current is 700μA. It is important that the op amp resistance stays within the range of 100GOhm.

INA129PAG4 Features
8 Pins
supply voltage of 15V
80dB voltage gain
Resistance of 100GOhm


INA129PAG4 Applications
There are a lot of Texas Instruments
INA129PAG4 Instrumentational OP Amps applications.


Logarithmic operation circuits
Exponential operation circuits
Multiplication circuits
Division circuits
Precision measurement
Power control
Information processing
Weak signal detection
Signal amplification
Signal filtering