Analog Devices Inc. AD8058ARM-REEL7

AD8058ARM-REEL7 Overview
In the package, you will find a 8-TSSOP, 8-MSOP (0.118, 3.00mm Width)-case to contain the op amp ic. The instrumentation amplifier in this picture is of the Voltage Feedback-type. A Tape & Reel (TR) case is used for delivering the op amp. The op amp ic has an array of 8 pins on it. Op amp rates 1mV as input offset voltage. For this electrical component, Surface Mount is the recommended mounting type. According to the manufacturer, this buffer op amp works well at -40°C~85°C , which is a good operating temperature. Using an 14mA supply current, this operational amplifier ics can be operated. It is recommended to keep the voltage gain at 55dB at all times. A instrumentation amplifier like this has 2 circuits. On the buffer amps, there are 2 channels that can be used. To operate this buffer amplifier, the temperature must not be lower than -40°C. A temperature greater than 85°C should not be used for the operation of this instrumentation amplifier. 2 elements make up the design of this buffer amplifier. The operating supply voltage of the buffer op amp is rated at 5V. There is a recommendation that this electrical part be used with a supply with 14mA current rating. This electric component can work from a voltage of under 12V as far as supply voltage is concerned. A voltage of 3V or higher is recommended for the linear amplifier's supply voltage. This electrical part should be conducted under the dual supply voltage of 6V volts when you conduct this part. The current is quiescent at 7.5mA. The buffer amplifier consists of 2 amplifiers.

AD8058ARM-REEL7 Features
55dB voltage gain


AD8058ARM-REEL7 Applications
There are a lot of Analog Devices Inc.
AD8058ARM-REEL7 Instrumentational OP Amps applications.


Multiplication circuits
Division circuits
Precision measurement
Power control
Information processing
Weak signal detection
Signal amplification
Signal filtering
Signal operation
Video computer boards