Analog Devices Inc. AD524SD/883B

AD524SD/883B Overview
Packaged in a 16-CDIP (0.300, 7.62mm) case, the buffer op amp is ready to use. An op amp ic of the Instrumentation type. The op amp is delivered to you in a Tube case. A total of 16 pins are present on the instrumentation amplifier. There is an input offset voltage of 250μV for this buffer op amp. The mounting type that is recommended for this electrical part is Through Hole. In relation to the operating temperature of this buffer op amp, it works well at an average of -55°C~125°C . As long as the supply current of the chip does not exceed 5mA, this op amp ic can operate. During the manufacturing process, this buffer amplifier is divided into 1 circuits. As far as the device is concerned, buffer amplifier has 1 channels. For the buffer op amp to operate properly, it must be above the temperature of -55°C degrees Celsius. No temperature greater than 125°C should be used. Depending on the chip's operating supply voltage, op amp ic has a rated voltage of 5. As a result, it is recommended that a power supply of 3.5mA be used with this electronic part. As a rule of thumb, you should conduct this electronic part under a dual voltage supply of 18V volts. Linear amplifier resistance should stay within the range of 1GOhm.

AD524SD/883B Features
Resistance of 1GOhm


AD524SD/883B Applications
There are a lot of Analog Devices Inc.
AD524SD/883B Instrumentational OP Amps applications.


Integrator circuits
Differentiator circuits
Logarithmic operation circuits
Exponential operation circuits
Multiplication circuits
Division circuits
Precision measurement
Power control
Information processing
Weak signal detection