Texas Instruments TPS2413DRG4

TPS2413DRG4 Overview
The case is 8-SOIC (0.154, 3.90mm Width)-shaped. In this case, it is suitable to pack the part in a Tape & Reel (TR) case. I would like to point out that the part is mounted in the way of Surface Mount. There is a voltage of 3V~16.5V applied to it. It is essential that the minimal operating temperature of this component is not -40°C~85°C. It fits the N 1 Power Supplies, High Availability-connected component. As far as the device classification is concerned, it falls under the N 1 ORing Controller category. N-Channel is the type of FET. The part comes with 8 terminations. There are 8 pins on it. The part is based on TPS2413. Powered by 5V, it delivers high performance. The peak reflow temperature of this part is used to run 260 on it. It is part of the Power Management Circuits family. This part contains 8 pins that are located on the surface. It is important that Vsup for this part does not fall below 3V. A supply current of 4.25mA is used to operate the device when it is in operation. A supply current (Isup) should be conducted under the condition 6mA. If the input voltage is greater than 16.5VV, this chip is capable of being used. There are certain situations in which the chip can be used with input voltages as low as 800mV V. 290μA is the output current that can be delivered to the component in terms of its output voltage. 1.2mA utilizes quiescent current.

TPS2413DRG4 Features
in a 8-SOIC (0.154, 3.90mm Width) case
FET Type: N-Channel
8 terminations
Peak Reflow Temperature (Cel) : 260

TPS2413DRG4 Applications
There are a lot of Texas Instruments TPS2413DRG4 Ideal Diode controller applications.

PCs
Industrial transport
Alternator
Electricity meters
Camera ECU
USB HUBs
ADAS domain controller
MP3 Players
Industrial motor drives
Electronic point of sale