Texas Instruments TL034CNSRE4

TL034CNSRE4 Overview
Packaged in a SOIC case, the buffer op amp is ready to use. An op amp ic of the OPERATIONAL AMPLIFIER type. The op amp is delivered to you in a Tape & Reel case. There is a growing number of terminations approaching the number of 14. The pins on this board total to 14 in total. I would like to remind you that this buffer op amp should be powered by an 5V battery. I would like to specify that this buffer amplifier belongs to the Operational Amplifier-type of devices. A total of 14 pins are present on the instrumentation amplifier. There is an input offset voltage of 790μV for this buffer op amp. As long as the supply current of the chip does not exceed 870μA, this op amp ic can operate. Keeping the voltage gain at 81.58dB is the best course of action. As far as the device is concerned, buffer amplifier has 4 channels. For the buffer op amp to operate properly, it must be above the temperature of 0°C degrees Celsius. No temperature greater than 70°C should be used. The operating supply voltage of the buffer op amp is rated at 15V. For packing the buffer amplifier, the TAPE AND REEL-axis is adopted. As a rule of thumb, you should conduct this electronic part under a dual voltage supply of 15V volts.

TL034CNSRE4 Features
14 Pins
supply voltage of 5V
81.58dB voltage gain


TL034CNSRE4 Applications
There are a lot of Texas Instruments
TL034CNSRE4 Instrumentational OP Amps applications.


Integrator circuits
Differentiator circuits
Logarithmic operation circuits
Exponential operation circuits
Multiplication circuits
Division circuits
Precision measurement
Power control
Information processing
Weak signal detection