Texas Instruments SN74HCT74DR

SN74HCT74DR Overview
The package is in the form of 14-SOIC (0.154, 3.90mm Width). D flip flop is embedded in the Cut Tape (CT) package. T flip flop uses Differentialas the output. This trigger is configured to use Positive Edge. There is an electrical part that is mounted in the way of Surface Mount. It operates with a supply voltage of 4.5V~5.5V. In this case, the operating temperature is -40°C~85°C TA. D-Typedescribes this flip flop. It belongs to the 74HCTseries of FPGAs. This D flip flop should not have a frequency greater than 46MHz. 14terminations have occurred. This D latch belongs to the family of 74HCT74. A voltage of 5V is used to power it. This T flip flop has a capacitance of 3pF farads at the input. Electronic devices of this type belong to the HCTfamily. There is an electronic part that is mounted in the way of Surface Mount. With its 14pins, it is designed to work with most electronic flip flops. The clock edge trigger type for this device is Positive Edge. It is part of the FF/Latchesbase part number family. The superior flexibility is achieved through the use of 2 circuits. Compared to other similar T flip flops, this device offers reliable performance and is well suited for TR. A total of 5V power supplies are needed to run it. The supply voltage should be maintained at 5V for high efficiency. The 25mA output current allows it to be designed with the greatest amount of flexibility. It is reported that there are 4 input lines. In terms of quiescent current, it consumes 4μA .

SN74HCT74DR Features
Cut Tape (CT) package
74HCT series
14 pins
5V power supplies

SN74HCT74DR Applications
There are a lot of Texas Instruments SN74HCT74DR Flip Flops applications.

Counters
Individual Asynchronous Resets
Single Up Count-Control Line
Matched Rise and Fall
Event Detectors
Clock pulse
Functionally equivalent to the MC10/100EL29
Differential Individual
Frequency Dividers
Frequency Divider circuits