Texas Instruments SN74ALS574BDWR

SN74ALS574BDWR Overview
The flip flop is packaged in a case of 20-SOIC (0.295, 7.50mm Width). It is contained within the Cut Tape (CT)package. There is a Tri-State, Non-Invertedoutput configured with it. JK flip flop uses Positive Edgeas the trigger. Surface Mountis positioned in the way of this electronic part. A supply voltage of 4.5V~5.5V is required for operation. It is operating at 0°C~70°C TA. D-Typeis the type of this D latch. This type of FPGA is a part of the 74ALS series. A frequency of 35MHzshould not be exceeded by its output. In total, it contains 1 elements. It consumes 18mA of quiescent A total of 20terminations have been recorded. The 74ALS574 family contains it. The power supply voltage is 5V. A device of this type belongs to the family of ALS. The electronic part is mounted in the way of Surface Mount. 20pins are included in its design. The clock edge trigger type for this device is Positive Edge. It is part of the FF/Latchesbase part number family. 8bits are used in its design. In order to achieve its superior flexibility, 8 circuits are used. Compared to other similar T flip flops, this device offers reliable performance and is well suited for TR. A total of 5V power supplies are needed to run it. The flip flop contains 2ports. In order to ensure high efficiency, the supply voltage should remain at 5V. The output current of 24mA makes it feature maximum design flexibility. As of now, there are 3input lines.

SN74ALS574BDWR Features
Cut Tape (CT) package
74ALS series
20 pins
8 Bits
5V power supplies

SN74ALS574BDWR Applications
There are a lot of Texas Instruments SN74ALS574BDWR Flip Flops applications.

Dynamic threshold performance
ATE
Common Clocks
Single Up Count-Control Line
Consumer
Automotive
Test & Measurement
Convert a momentary switch to a toggle switch
Latch-up performance
ESD performance