Texas Instruments SN74ALS174NSR

SN74ALS174NSR Overview
The item is packaged in 16-SOIC (0.209, 5.30mm Width)cases. Package Cut Tape (CT)embeds it. Currently, the output is configured to use Non-Inverted. The trigger it is configured with uses Positive Edge. There is an electric part mounted in the way of Surface Mount. A voltage of 4.5V~5.5Vis required for its operation. 0°C~70°C TAis the operating temperature. This electronic flip flop is of type D-Type. FPGAs belonging to the 74ALSseries contain this type of chip. In order for it to function properly, its output frequency should not exceed 50MHz. The element count is 1 . It has been determined that there have been 16 terminations. D latch belongs to the 74ALS174 family. Power is provided by a 5V supply. An electronic device belonging to the family ALScan be found here. There is an electronic part that is mounted in the way of Surface Mount. A total of 16pins are provided on this board. There is a clock edge trigger type of Positive Edgeon this device. This part is included in FF/Latches. To achieve this superior flexibility, 7 circuits are used. A reliable performance of this D flip flop makes it well suited for use in TR. A total of 5V power supplies are needed to run it. It is recommended that the supply voltage be kept at 5Vto maximize efficiency. With an output current of 8mA, it is possible to design the device in any way you want. There are 2 output lines in this JK flip flop. This input has 3lines. In terms of quiescent current, it consumes 19mA .

SN74ALS174NSR Features
Cut Tape (CT) package
74ALS series
16 pins
5V power supplies

SN74ALS174NSR Applications
There are a lot of Texas Instruments SN74ALS174NSR Flip Flops applications.

Test & Measurement
Shift Registers
Supports Live Insertion
Storage Registers
Convert a momentary switch to a toggle switch
Frequency division
Balanced Propagation Delays
Patented noise
Digital electronics systems
Buffered Clock