Texas Instruments SN74AHC374DBR

SN74AHC374DBR Overview
It is packaged in the way of 20-SSOP (0.209, 5.30mm Width). It is included in the package Cut Tape (CT). There is a Tri-State, Non-Invertedoutput configured with it. Positive Edgeis the trigger it is configured with. The electronic part is mounted in the way of Surface Mount. A 2V~5.5Vsupply voltage is required for it to operate. It is operating at -40°C~85°C TA. Logic flip flops of this type are classified as D-Type. The FPGA belongs to the 74AHC series. Its output frequency should not exceed 120MHz Hz. D latch consists of 1 elements. It consumes 4μA of quiescent There are 20 terminations,The object belongs to the 74AHC374 family. A voltage of 3.3V provides power to the D latch. Its input capacitance is 4pF farads. The electronic device belongs to the AHC/VHC/H/U/Vfamily. There is an electronic part mounted in the way of Surface Mount. It is designed with 20 pins. This device has Positive Edgeas its clock edge trigger type. The part you are looking for is included in FF/Latches. It is designed with 8bits. As soon as 5.5Vis reached, Vsup reaches its maximum value. A normal operating voltage (Vsup) should remain above 2V. Due to its superior flexibility, it uses 8 circuits. Compared to other similar T flip flops, this device offers reliable performance and is well suited for TR. The power supply is 2/5.5V. The D flip flop is embedded with 2ports. The output current of 8mA makes it feature maximum design flexibility. 3input lines are available for you to choose from.

SN74AHC374DBR Features
Cut Tape (CT) package
74AHC series
20 pins
8 Bits
2/5.5V power supplies

SN74AHC374DBR Applications
There are a lot of Texas Instruments SN74AHC374DBR Flip Flops applications.

Computers
Shift Registers
Memory
Load Control
Bounce elimination switch
Divide a clock signal by 2 or 4
ESD protection
Data Synchronizers
Latch-up performance
Data storage