Texas Instruments INA200AIDRG4

INA200AIDRG4 Overview
In the package, you will find a SOIC-case to contain the op amp ic. The instrumentation amplifier in this picture is of the COMPARATOR-type. A Tape and Reel case is used for delivering the op amp. During the past two weeks, there have been close to 8 terminations. A total of 8 pins are located on this board. This linear amplifier should be powered by an 12V battery. This particular linear amplifier is a type of Operational Amplifier device, to be precise. The op amp ic has an array of 8 pins on it. On the buffer amps, there are 1 channels that can be used. Buffer amplifier produces OPEN-DRAIN signals, which is one of its many benefits. To operate this buffer amplifier, the temperature must not be lower than -40°C. A temperature greater than 125°C should not be used for the operation of buffer amplifier. This electric component can work from a voltage of under 18V as far as supply voltage is concerned. A voltage of 2.7V or higher is recommended for the linear amplifier's supply voltage.

INA200AIDRG4 Features
8 Pins
supply voltage of 12V
Output Type: OPEN-DRAIN


INA200AIDRG4 Applications
There are a lot of Texas Instruments
INA200AIDRG4 Instrumentational OP Amps applications.


Multiplication circuits
Division circuits
Precision measurement
Power control
Information processing
Weak signal detection
Signal amplification
Signal filtering
Signal operation
Video computer boards