CUI Inc. CMA-4544PF-W

Part Status is an electronic component parameter that indicates the availability and production status of a component. It is typically used to inform customers about the availability of a component, whether it is in production, end-of-life, or obsolete. Part Status can also provide information about any restrictions or limitations on the component's use, such as whether it is only available for certain applications or if it has been discontinued.

Moisture Sensitivity Level (MSL) is a measure of the susceptibility of a surface mount electronic component to moisture-induced damage during soldering. It is classified into six levels, from 1 (least sensitive) to 6 (most sensitive). MSL is determined by the materials used in the component's construction, including the solderability of its terminals and the presence of moisture-absorbing materials. Components with higher MSL ratings require more stringent handling and storage conditions to prevent moisture absorption and subsequent damage during soldering.

Voltage - Rated refers to the maximum voltage that an electronic component can withstand without being damaged. It is typically specified in volts (V) and is an important parameter to consider when selecting components for a circuit. Exceeding the rated voltage can lead to component failure, so it is important to ensure that the voltage applied to a component does not exceed its rated voltage.

Impedance is a measure of the opposition to the flow of alternating current (AC) in an electrical circuit. It is a complex quantity that has both magnitude and phase. The magnitude of impedance is measured in ohms, and the phase is measured in degrees. Impedance is determined by the resistance, inductance, and capacitance of the circuit. Resistance is the opposition to the flow of current due to the material of the conductor. Inductance is the opposition to the flow of current due to the magnetic field created by the current. Capacitance is the opposition to the flow of current due to the storage of charge on the plates of a capacitor.

Frequency Range is the range of frequencies over which an electronic component can operate effectively. It is typically specified in Hertz (Hz) and indicates the lowest and highest frequencies at which the component can perform its intended function. For example, an amplifier may have a frequency range of 20 Hz to 20 kHz, indicating that it can amplify signals within that range of frequencies. The frequency range of a component is important for ensuring that it is suitable for the intended application.

Sensitivity is a measure of how much the output of an electronic component changes in response to a change in the input. It is typically expressed in units of volts per volt (V/V), amps per amp (A/A), or decibels (dB). A high sensitivity indicates that the component will produce a large output change for a small input change. This is desirable in many applications, such as amplifiers and sensors. A low sensitivity indicates that the component will produce a small output change for a large input change. This is desirable in some applications, such as voltage regulators and current limiters.

Height, in the context of electronic components, refers to the vertical dimension of the component. It is typically measured in millimeters (mm) or inches (in). Height is an important parameter to consider when designing and assembling electronic circuits, as it affects the overall size and form factor of the device. Components with a smaller height are often preferred for applications where space is limited, such as in portable devices or embedded systems.