Texas Instruments ADC12130CIWM

Mounting Type refers to the method by which an electronic component is attached to a printed circuit board (PCB) or other surface. Common mounting types include: * Through-hole: Component leads are inserted into holes in the PCB and soldered on the other side. * Surface-mount: Component is placed on the surface of the PCB and soldered in place. * Press-fit: Component is pressed into place on the PCB without soldering. * Socket: Component is inserted into a socket on the PCB, allowing for easy replacement. The mounting type is determined by factors such as the component's size, shape, and power requirements.

Operating Temperature is the range of temperatures at which an electronic component can function properly. It is typically specified in degrees Celsius (°C) and indicates the minimum and maximum temperatures at which the component can operate without experiencing damage or degradation. Operating Temperature is an important parameter to consider when designing electronic circuits, as it ensures that the components will function reliably in the intended operating environment.

Part Status is an electronic component parameter that indicates the availability and production status of a component. It is typically used to inform customers about the availability of a component, whether it is in production, end-of-life, or obsolete. Part Status can also provide information about any restrictions or limitations on the component's use, such as whether it is only available for certain applications or if it has been discontinued.

Moisture Sensitivity Level (MSL) is a measure of the susceptibility of a surface mount electronic component to moisture-induced damage during soldering. It is classified into six levels, from 1 (least sensitive) to 6 (most sensitive). MSL is determined by the materials used in the component's construction, including the solderability of its terminals and the presence of moisture-absorbing materials. Components with higher MSL ratings require more stringent handling and storage conditions to prevent moisture absorption and subsequent damage during soldering.

Supply Voltage is the voltage required to power an electronic component. It is typically measured in volts (V) and is specified in the component's datasheet. The supply voltage must be within the specified range for the component to function properly. If the supply voltage is too low, the component may not function at all. If the supply voltage is too high, the component may be damaged.

Polarity refers to the direction of current flow through an electronic component. It is typically indicated by a plus (+) or minus (-) sign on the component's body. Components with polarity must be connected correctly in a circuit to function properly. For example, a diode will only allow current to flow in one direction, from the positive terminal to the negative terminal. If a diode is connected backwards, it will not conduct current.

Input Type refers to the type of signal that an electronic component can accept as input.

Converter Type refers to the type of conversion performed by an electronic component, such as an analog-to-digital converter (ADC) or a digital-to-analog converter (DAC). It specifies the input and output signal types that the converter can handle.

Sampling rate refers to the number of times per second that an analog signal is measured and converted into a digital signal. It is expressed in Hertz (Hz) and determines the maximum frequency that can be accurately represented in the digital signal. A higher sampling rate results in a more accurate representation of the analog signal, but also increases the amount of data that needs to be processed. The sampling rate must be at least twice the highest frequency component of the analog signal to avoid aliasing, where high-frequency components are incorrectly represented as lower-frequency components.

Ratio - S/H:ADC is an electronic component parameter that specifies the ratio of the output voltage of a sample-and-hold (S/H) circuit to the input voltage of the analog-to-digital converter (ADC). It is expressed as a percentage and indicates the accuracy of the ADC's conversion process. A higher ratio indicates better accuracy, as it means that the ADC is able to convert the analog input signal into a digital representation with less error.